AAD Performance C004-0000 - LX/LC Front Upper Control Arm Set, Black Anodized with Spheriflex Bearings

Full billet aluminum, fully-adjustable Front Upper Control Arms for your 2WD Charger, Challenger, Magnum, 300, Hellcat, etc. These Arms use AAD's unique tab-lock system to facilitate easy, on-vehicle Camber adjustment so that when you lower your ride, you can get your Front Camber back in spec. Utilizing AAD's Patent Pending Spheriflex bearing, a teflon impregnated Delrin spherical bearing, to reduce or eliminate the slop in the OEM parts.

AAD parts are all precision machined from 6061-T6511 billet aluminum and 17-4 Stainless steel. Tabs are laser-cut for exact fit, and all hardware is high-strength with OEM-quality plating to resist corrosion. AAD's arms weigh approximately 1 pound less than the OEM parts (each) but are significantly stronger in all directions.

AAD use a high-end, FK stainless-steel, Teflon-lined spherical bearing for the joint that is angled 5-degrees to prevent joint bind at full droop. This bearing is replaceable and will last for years without issue.

In short, AAD has done everything we can to make sure these parts fit exactly right, provide all the adjustment you could need (up to +/- 8mm as compared to stock) and give nothing but trouble-free years of service even under harsh conditions.

If you are a road race/autox guy looking for more negative camber, please let us know at the time the order is placed, as otherwise we will assume that you are wanting to reduce camber as that is most common. Thanks!