Chevrolet Performance 19433632 - LT4 Wet Sump Module Kit with 3–Pin Sensor & 6L80 transmission 2022+

Description

These kits include all the components required to connect to the engine and ECM to get your hot rod running. Detailed GM instructions will guide you through the process to insure a perfect installation for the beginner or the professional.

This control system is intended for use with a returnless fuel system and fuel pump that is capable of being pulse width

modulated (PWM) at 25 kHz to control fuel pressure. A fuel flow rate of 65 G/H (Gallons Per Hour) at 72 psi (500 kPa) is recommended for optimum

performance. Because this is a dead headed system, a pressure relief set at 84 psi (580 KPa) must be included in the fuel line between the tank pump and

engine mounted high pressure pump.

Some Engine Controller Kits may vary with small components that are included due to variations in engine applications.

Most kits contain the following items:

• Sensors:

  Oxygen Sensors
  

  Mass Air Flow Meter (MAF)
  

  Oil Pressure Sensor and Harness
  

  (NOTE: Some crate engines have the the sensor installed from the factory)
  

  Fuel Pressure Sensor Kit
  

• Hardware:
  

  O2 Sensor Mounting Bosses
  

  MAF Mounting Kit
  

  Drive-By-Wire Throttle Pedal Assembly
  

  Complete Engine/ECM Wiring Harness with a Fuse Box
  

  Fuel Pump Power Module
  

  GM Fully Calibrated ECM
  

• Instructions:
  

  Detailed Instruction Sheet
  

For LT4 Controller for 4L Automatic and 6 Speed Manual: 19433248

For LT4 Controller for 8L and 10L Automatic: 19433249